Working with KHIKA Adapters

From khika
Revision as of 07:48, 10 June 2019 by Dhanashree kulkarni (talk | contribs) (Created page with " == Introduction == Adapters are data collection programs (scripts or executables) run by the KHIKA data collection framework at a predefined polling interval on the configur...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Introduction

Adapters are data collection programs (scripts or executables) run by the KHIKA data collection framework at a predefined polling interval on the configured Data Aggregators. An Adapter reads the data/log messages from a data source when they appear, parses them to useful tokens (KHIKA Data format), and then writes them back to standard output (stdout) in the KHIKA data format. To access Adapter tab, go to the main screen, click the left side menu bar. Click Configure and then click Adapter tab. The following screen is displayed.


adapter1


Adding Adapters

To access Adapter tab, go to the main screen, click the left side menu bar. Click Configure and then click Adapter tab. To add an Adapter, click Add Adapter button shown.The following dialog box is displayed.


adapter2


Click on “Add Adaptor” button. Following pop up appears. Enter adaptor details as mentioned.


adapter3


The fields in the pop up are explained


table


The Adapter is added successfully, and the confirmation message is displayed as shown below.


adapter4


Searching Adapters